Archives

Glue-Up Helper I've always struggled with the rubber bands I use to hold jewelry box sides square and steady during glue-up. The biggest pain in the neck was cleaning the glue squeeze-out [...]

Tabletop Connection Steel tabletop fasteners are a great way to attach a tabletop to its base while still allowing for seasonal changes. On a table with straight aprons, it’s easy enough to [...]

Tablesaw Sled Cutoff Block My sliding cutoff sled gets lots of use for repetitive cuts. In the past, I clamped a board to use as a stop, but moving it for different cuts became cumbersome. To [...]

Getting the Point I frequently use awls in my work and like to keep them needle-sharp. This little jig takes only a few minutes to make and guarantees a fine, tapered point. The magnets keep the [...]

Flammables Cabinet Keep your shop and family safe! Have you got finishing supplies scattered all over your shop? Concerned that they’re a fire hazard? Organize them into this cabinet built [...]

Cross-Grain Trim I recently needed to attach molding across the sides of some bookcases. Because the sides were solid wood, I had to allow for some seasonal movement. I used a table-mounted [...]

Repairing Ripped Belts Sanding belts can rip at the worst possible moment – such as when you're out on a jobsite with no spares. When this happens I remove the belt, turn it inside out [...]

Tablesaw Jig Clamp I added this hold-down to my tablesaw’s sliding cutoff jig and find it a great convenience, because the height of the clamp is easily changed. This clamp uses a standard [...]

Tablesaw Storage Cabinet All of your tablesaw accessories close at hand By Eric Smith The last time I could find them all, I counted 18 accessories for my tablesaw. Dado set, push sticks, throat [...]

Glove Finger Chisel Protectors My Chisels used to get dull and rusty rattling around in my toolbox. No more! I found a clever way to protect them. I cut the fingers off some old leather work [...]

Router Base Transfer Points After I lost track of the base plate for the router that goes in my router table, I had to make a new one with accurately marked holes for the mounting screws and a [...]

Vise Crank Handle I'm getting up in years but I still love woodworking. My hands aren't as limber as they used to be, so it was uncomfortable to twist my vise handle. I remembered the [...]