Archives

Knot-Free Planing I use a lot of #2 pine boards, but when I plane them, the knots often nick my knives. I found a way to prevent this by cutting out the knots before I plane. Because most of my [...]

The Ultimate Shop-Built Crosscut Sled It's safe, it slides like a dream and replaceable throat plate makes it last forever! By Travis Larson A good tablesaw sled makes perfect crosscuts easy, [...]

Stable Roller Stand I bought a roller stand to support my lumber when sawing. It worked okay, but sometimes the rear leg would fold up and the stand would collapse. This was very annoying. I [...]

Flip-Top Sawhorses I got tired of rummaging around for a blanket or anything soft to lay my finished projects on, so I rigged up these simple carpet caps that fit on top of my sawhorses. They [...]

Photo 1                                                     [...]

Plane Stand Every so often I need to plane down a piece of wood that is too small for my jointer. To handle these small jobs, I devised a stand for my No. 5 Stanley jack plane. The plane rests …

  Behind the Stairs Storage In my basement shop every square inch counts! Out of necessity I found a wealth of unused space tucked right under my nose, or should I say feet. That awkward [...]

Roll-Around Shop Cabinet This wooden cavern holds tons of tools, plus it doubles as a bench outrigger. By Ian Kirby For tough and intelligent tool storage, it’s hard to beat a professional [...]

Straight-Shooting Drill Jig You may not face this problem often, but when you need to drill a hole nice and straight but the part is too big to fit on the drill press, here’s what to do: [...]

Double-Decker Mini Clamp Here's a great little clamp for those light-duty hobby or craft jobs. Start with two ordinary clothespins, then modify and combine them as shown above. You now have a [...]

Workbench Joint Plans for my knock-down workbench called for the 2 x 4 stretchers to be fastened with bolts and hex nuts. I'd have to rout huge pockets, weakening the stretcher, in order to [...]

Edge-Banding Clamp I ran out of clamps and patience the last time I applied a veneered edge to a long piece of plywood. The tangle of clamps to hold the veneer and cauls in place was more than I [...]