Archives

Here is my adjustable jig for ripping thin strips on a table saw. Used with a push stick and zero-clearance insert, it keeps my hands a safe distance away from the sawblade. The base is MDF [...]

My contractor saw shares a garage with my car, so it’s stowed against a wall when not in use. It’s not an easy thing to drag into place when it’s time to set up for woodworking, so I decided to [...]

I find cutting dowels on the band saw to be a hassle. For one thing, the blade can grab the round stock and twist it out of your hand if you’re not using a support cradle guided by the miter …

I edge-band plywood shelves with solid wood, attaching the edge-banding with #20 biscuits. It’s no problem at all to hold the plywood shelf solidly while cutting the slot; that’s what bench dogs [...]

Planing stock to fit standard dados is much easier than trying to find the right chipper and shim combination to fit the dado to your stock. I cut five grooves in a scrap of plywood, using only [...]

Occasionally, I like to veneer my own cabinet doors. Like many small-shop woodworkers, I do the job by covering the veneered face with a platen, then applying clamping pressure onto the work via [...]

Making long, perfectly straight cuts with handheld power saws, such as jigsaws and circular saws, can be a real challenge. They aren’t difficult when a straightedge is used as a guide, but [...]

I needed an easy-access storage unit that wouldn’t take up a lot of room but would hold a large number of tools. My solution was a wall-hung tool cabinet with slide-out vertical pegboard drawers. [...]

This simple jig enables you to cut accurate tenons and slice very thin pieces. I use a flush-cut saw because it has no set to its teeth and, therefore, won’t damage the jig. Plus it leaves a [...]

A piece of thick plate glass is dead flat and it’s easy to use to align standard jointer knives that have gib screws. A couple of rare-earth magnets secured to the glass with double-sided tape [...]

Like many woodworkers, I own a basic half-blind dovetail jig, which I use only occasionally for making utility drawers. During the interim, I tend to forget the setup procedures and spacing [...]

Hole saws provide an inexpensive way to bore large holes, but they have a maddening tendency to clutch the drilled disk afterward. I’ve found that the best approach for removing a stuck disk from [...]