Editor’s note: Special thanks to reader Bob L, who pointed out that putting a rare earth magnet that close to a moving saw blade can have catastrophic consequences. If you choose to use [...]
Ordinary push pads tend to slip, I’ve found, when face-jointing a board. I modified one of mine by cutting 1/2″ of the rubber padding off its back end and then screwing on a 1/2″ x [...]
A push stick is a familiar device to prevent kickback while ripping a board, but I prefer to use a “push shoe.” It’s shaped like a shoe with a handle, and has a heel, just like a boot. The [...]
This handle design is a safety improvement over commercial versions. Let’s face it: Many of us all too often see safety as…well, just plain boring. We always seem to be anxious to use that little [...]
A push pad is essential for jointing, routing or ripping because it keeps your fingers away from the danger zone. I’m always on the lookout for a pad that’s larger and grippier than [...]