We may receive a commission when you use our affiliate links. However, this does not impact our recommendations.
Basically, just four different kinds of parts, you'll need to make two of the front and back legs
Antlers, note the grain direction. Use a 3/8s round-over bit on both sides, the notch is cut to fit the notch in the body
rear leg, the notch at the back is about 3/8", round over on the outside only
front leg, again, just round over the outside edges.
Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.