We may receive a commission when you use our affiliate links. However, this does not impact our recommendations.
REMEMBER THE DOG TEETH USED TO CONNECT TIMBER JOIST TOGETHER. THIS TEETH IS ALSO GOOD ON WOOD TURNING,HOLDING WORK PIECE IN PLACE WHILE TURNING.
ONCE IT HAS BEEN SCREWED TO FACE PLATE WITH THE 2 HOLES IN THE TEETH,YOU THEN CENTRE YOUR PIECE A SLIGHT TAP AND BRING TAIL STOCK UP TO OTHER END TIGHTEN AND WIND IN TAIL STOCK.QUICK AND EASY PLUS COST YOU £1 OR $1.44 FOR 6.THESE IDEAS I HAVE ARE TRIED AND TESTED PLUS THIS WAS SPINNING AT 2200RPM.AND IT HOLDS WELL.AS YOU NOTICE THE FACE PLATE HAS A PLY BOARD ON FRONT SO I COULD SCREW DOG TEETH TO IT! I USE TO SCREW FROM THE BACK OF A FACE PLATE MY PIECE I WAS GOING TO TURN.THAT WAS ALL TIME COSUMMING. NOW ALL I DO IS ATTACH DOG TEETH WITHIN IN A MATTER OF SECONDS AND AWAY YOU TURN.PLUS YOU HAVE 10 TEETH HOLDING YOUR WORK PIECE. THE PHOTO YOU SEE WITH LOG ON LATHE WAS NOT SET UP STRAIGHT IT WAS SLIGHTLY TILTED TO SHOW YOU THE TEETH ON THE FACE PLATE..A UNIQUE BUT SIMPLE IDEA AND IF YOUR WORKING ON A BUILDING SITE YOU CAN PICK THESES UP ANYWHERE.AND FOR FREE EVEN BETTER.!!!
Here are some supplies and tools we find essential in our everyday work around the shop. We may receive a commission from sales referred by our links; however, we have carefully selected these products for their usefulness and quality.
